Fitter interview in Skilled Visas Posted January 1 3 minutes ago, Lavers said: Below is what I posted after I did my metal fabricator interview and if I remember correctly I think there is welding units on the fitter units. So I've just finished my technical interview and I though I'd pass on what to expect. Like everyone says it's very informal and it's just like your having a chat with someone at work. If there's areas your stuck on they help you best you can to give an answer. So questions they asked where: *Give measurements off a drawing on screen. *Name tools on screen ie. Tape measure, rule and vernier (tricky). *Talk about mechanical tools you use, with correct PPE and also what checks you do before using. *Talk about what parts you need to set up Tig,Mig and stick welding sets. * What gases you use for each and different tungsten for the ie. Red & Grey. * Shown me a couple of weld symbols and asked what they where. * What first aid and quality procedures your company has. *What's on a WPS sheet and also COSSH. Bit gutted they didn't ask about pattern development as I've been brushing up on it over the last few days. All in all it took 1hr 10min as if you'd answered things in another question he'd skip a few. Hope this helps Thx you for your help mate appreciate that.